Service and Repair Manual Repair
Fuel system
Fig. 146: Connecting electrical contacts
u Connect electrical cables on the corresponding solenoid connector.
u Tighten to torque.
Specific values
Not applicable.
Tightening specifications
q Put all parts in place and tighten by hand before following the sequence.
Information
Refer to screws reuse rules. (For more information see: 5.3.2 Screws pre-tightening, reuse and
marking, page 274.)
Fig. 147: Injector
KD83V16 33525088901_2_1 EN_US
2021-07
© 2021 by Kohler Co. All rights reserved.
129
To Next Page
Loading...
