KOHTECT qb701 - MOUNTING TRANSDUCERS; Mounting Transducers

qb701 User’s Manual
10
4
1
3
2
5
1
MOUNTING TRANSDUCERS
• Firmly tighten rods 1 into the shaft brackets 2.
• Put thumb nut 3 into the bracket 2, then hook the chain 5 on the stud 4.
• Firmly tighten the thumb nut 3. Shaft brackets with rods must be mounted at the
same angular position.
• Mount transducers on the rods. Always try to mount transducers at minimal
possible radial height. Make sure that transducers are not touching brackets or
machine parts.
S, M transducers to be
installed at the same
height with labels faced up
Datum lines for measuring
of dimension input
Locking
thumb nut
M transducer
installed on
the machine
to be moved
S transducer
installed on
the stationary
machine