qb701 User’s Manual
31
Multipoint mode – measurements may be taken at any minimum 3 up to 36 positions.
After taking enough readings one should press to proceed to the result screen. For
Vertical machines inclinometer data is unavailable, so angle value for each point should be
entered manually, taking into account mentioned above positions conventions.
Press to enter tolerance setup menu.
Press to use predefined RPM/tolerance table
Press to enter user defined tolerance values
Press to save changes, to discard changes.
TAKING MEASUREMENTS. CLOCK MODE
Press to edit dimensions.
Mark on the machine measurement positions separated by 90° (or
45°)
Set parameters and enter dimensions then press key to
proceed.
Turn shafts to first position – 9 o’clock (90°)
Press to take first reading.
To Next Page
Loading...