KOHTECT qb701 - PARAMETERS FOR VERTICAL ALIGNMENT; Parameters for Vertical Alignment

To Next Page

To Previous Page

qb701 User’s Manual

PARAMETERS

In Main Menu run Vertical program.

Choose New Task.

Machine dimensions / measurement setup screen

Press key to edit dimensions values

Press key for parameters/key legend:

Press - to toggle data input – LD transducer’s data / MD –

manual data

Press - to toggle angle input – IA use inclinometer / MA

manual angle. Manual angle input used for vertical machines,

since electronic inclinometer cannot be used.

Press - to toggle displayed precision – 2 or 3 digits.

Press - to toggle measurement mode: Clock mode 9-12-3 o’clock – readings to be

taken at three predefined shaft positions – 9 o’clock, then 12 o’clock, then 3 o’clock.

Device will proceed to the result screen then.

Press to switch displayed units mm/inch