Vers. 111219 Page 28
EDU EXPAND
EDU EXPAND is the software for pc created by Kolver to set, change and save all parameters of
EDU2AE/TOP/E or EDU2AE/TOP/TA 3.0 unit.
It communicates with the control unit via miniUSB or RS232 and makes you create up to 100 different
settings configurations, save them on your USB drive and then recall on your EDU unit.
Just connect your USB drive to the port on the front panel of the EDU unit and recall the desired program on
the menu (see Menu Options, USB Options).
At the same time the programs set on control unit can be downloaded on USB and recalled on another unit
and on EDU EXPAND, too.
Here is a quick guide to use EDU EXPAND.
Double click the icon program and this is the main view.
- New program: to load a new program.
- Load from file: it loads all programs, sequences and option settings from a previously saved file on
your computer.
- Load from unit: it loads all program, sequence and option settings from the unit. The unit must first
be connected to the pc using Scan ports.
- Scan port: it locates the unit. EDU EXPAND recalls the port, the model of the control unit and its
serial number.
-
The control unit must be connected to the PC via miniUSB port or RS232 seat in the back panel of the
unit.
If you cannot locate the control unit, make sure the unit and PC are connected properly or that the unit
is on the initial screen of the Menu.
To Next Page
Loading...
Need help?
General
