When the machine is traveling, turn steering wheel (1) in the
desired direction.
The machine turns.
On roads where there are curves, let the accelerator pedal
back before coming to the curve, shift down to the lowest
speed range possible then depress the accelerator pedal again
to continue driving.
Do not coast at high speed on a curved road.
REMARK
• The angle of the steering wheel may change (the position
of the spoke may change slightly) when the machine is
traveling, but this is not a failure.
• If force is applied to the steering wheel when the tires have
been turned fully to the right or left, the steering wheel will
turn a little at a time, but this is not a failure.
OPERATE WITH INTER-AXLE DIFFERENTIAL LOCK
During traveling on dry sandy ground, etc., tire may slip and the machine may be vibrated up and down. In this
case, use the inter-axle differential lock switch before driving the machine.
NOTICE
Do not use inter-axle differential lock.
If inter-axle differential lock is used,
• it will be more difficult to operate the steering wheel.
• It will become more difficult to turn than it should be when the inter-axle differential lock is not
used, and in some cases, it may not be possible to steer around curves which were previously pos-
sible.
How to use inter-axle differential lock
Inter-axle differential lock switch
AUTOMANUAL
§Actuated §Cancel
Inter-axle differential lock
Terminology
Inter-axle differential lock switch
Inter-axle differential lock switch
Manual Manual
MACHINE OPERATIONS AND CONTROLS OPERATION
3-196
To Next Page
Loading...
