Rear suspension (right and left) (2 places each)
EVERY 250 HOURS MAINTENANCE
Maintenance for every 50 hours service should be performed at the same time.
METHOD FOR LUBRICATING
1.
Operate the dump body to be seated on a level ground.
2.
Stop the engine.
3.
By using a grease pump, pump in grease through the grease fittings.
4.
Check visually that the greasing has been performed properly.
5.
After greasing, wipe off any old grease that is pushed out.
Perform the greasing work every day when operating in places where the grease flows out easily, such as when
traveling through mud or water.
Steering cylinder (left) (2 places)
Steering cylinder (right) (2 places)
MAINTENANCE MAINTENANCE PROCEDURE
4-37
To Next Page
Loading...
