Komatsu HM400-5 - Precautions for Lifting Machine

5.
Put blocks in front of and behind the tires and secure the
machine with chains or wire rope of a suitable strength to
prevent the machine from moving during transportation.
In particular, fix the machine securely to prevent it from
slipping sideways.
NOTICE
Always retract the antenna.
Reassemble the mirrors so that they are within the
width of the machine.
PRECAUTIONS FOR LIFTING MACHINE
When lifting the machine at a port or any other place, always use the following procedure to lift it.
kk
WARNING
• The person using the crane to perform lifting operations must be a qualified crane operator.
• Do not lift the machine with someone in it.
• Always use a wire rope that has ample strength for the weight of the machine being lifted.
• When lifting, keep the machine horizontal.
• Before starting the lifting operation, always stop the engine, apply the parking brake, and use the
articulation lock to prevent the front frame from articulating.
• Never enter the area under or around a lifted machine.
Never try to lift the machine in any other posture or by using any other lifting equipment than those given in the
following procedures.
There is a danger that the machine loses its balance.
NOTICE
This method of lifting applies to the standard specification machine.
The method of lifting differs depending on the attachments and options installed.
For details of the procedure for machines that are not the standard specification, consult your Komatsu
distributor.
For the weight of standard specification machine, see “Weight table”.
NOTICE
• Use protectors, etc. so that the wire ropes will not be broken at sharp edges or narrow places.
• When using a spreader beam, select an ample width to prevent contact with the machine.
Consult your Komatsu distributor before performing lifting work.
TRANSPORTATION OPERATION
3-240