METHOD FOR LUBRICATING DRIVE SHAFT
When greasing, use lithium grease (G2-LI), and perform the greasing every 6000 hours or every 2 years.
When getting on or off the machine with carrying grease, a tool
etc., place it once in part (A) to ensure your safety.
1.
Stop the engine.
2.
By using a grease pump, pump in grease through the
grease fittings shown by arrows.
3.
Grease the spider portion until grease comes out from the
cap seal.
4.
Check visually that the greasing has been performed prop-
erly.
5.
After greasing, wipe off any old grease that is pushed out.
METHOD FOR CHECKING LOCATION OF FRONT DRIVE SHAFT GREASE FIT-
TING
WARNING
When checking the positions of the grease holes and grease fittings, ensure that the machine is stop-
ped.
It is very dangerous to check the positions of the grease holes and grease fittings while the machine is
running.
Check that grease hole (1) of the A-arm (at the rear of the machine) is matched with grease fitting (2) of the
spider.
If grease hole (1) is not matched with grease fitting (2) of the spider, match them according to the following pro-
cedure.
MAINTENANCE MAINTENANCE PROCEDURE
4-85
To Next Page
Loading...
