DISPLAY TOTAL PAYLOAD AND NUMBER OF CYCLES
You can display the accumulated payload and the total number of cycles which are integrated at each dumping.
You can reset those values as well.
1.
Press menu switch (1) on the standard screen and display
“Machine Setting and Information” menu. Select “Payload
Meter” and press enter switch (2).
2.
Select “Accumulated Payload and Total Cycles” and press
enter switch (2).
The accumulated payload and the total number of cycles
are displayed as shown in the figure.
• The data and time of start are those when “Accumulat-
ed Payload and Total Cycles” were reset last time.
• The date and time of finish are those of the last dump-
ing.
• “Accumulated Payload and Total Cycles” are the inte-
grated values after the previous resetting.
• The display range is from 0 to 99999999.9t and 0 to
999999 cycles respectively. When they reach the up-
per limits, they are kept at the upper limits until they are reset.
HANDLING PAYLOAD METER ATTACHMENTS AND OPTIONS
6-12
To Next Page
Loading...
