1.
Remove cap (1).
2.
Connect the download cable attached to the special soft-
ware to the download connector.
3.
Connect the other end of the download cable to RS232C
port of the personal computer.
4.
Turn the starting switch to ON position.
5.
Start up the personal computer and use the special soft-
ware to download the data.
You can use the card type payload meter download soft-
ware for HM400 as it is.
For details of installing the software, see the instruction
manual provided with the download software.
When the installation is completed, the icon shown in the
figure is created.
1)
Double-click the icon.
The download software is started and the screen
shown in the figure is displayed.
2)
When screen “G1000” is displayed, click “PLM”.
Screen “G2000” is displayed.
Do not click “CARD” and “PMC”, since they are not
used.
3)
Click “Parameter Setting” on screen “G2000”.
Screen “G2200” is displayed.
Do not click “PLM Remote Control”, since it is not
used.
HANDLING PAYLOAD METER ATTACHMENTS AND OPTIONS
6-10
To Next Page
Loading...
