20 Standard value table SEN00261-02
114E-3 Series
9
Run-in standard
a The loads for the dynamometer are at an arm’s length of 716 mm.
Performance test criteria
a This table shows the standard values using the JIS correction factor.
a This table shows the standard values with an air cleaner installed, muffler installed, alternator under no
load.
a The dynamometer load shows the value for an arm length of 716 mm.
a Use ASTM D975 diesel oil as the fuel.
a Use SAE15W-40 as the lubricating oil.
Engine SAA6D114E-3
Applicable machine GD655-3E0, GD675-3E0
Item
Procedure
12345
Running time min 2 10 2 3 10
Engine speed rpm 825 1,000 1,200 1,600 1,900
Dynamometer load N {kg} 0 {0} 98 {10} 245 {25} 637 {65} 1,090 {111}
Output kW {HP} 0 {0} 7.4 {10} 22 {29.5} 76 {102} 154 {206}
Engine SAA6D114E-3
Applicable machine GD655-3E0, GD675-3E0
Test item Rated horsepower Max. torque
High idle
speed
Low idle
speed
Specification value
(Gross)
—
154 kW / 1,900 rpm
{206 HP / 1,900 rpm}
990 Nm / 1,450 rpm
{101 kgm / 1,450 rpm}
2,225 rpm 825 rpm
Speed rpm 1,900 1,450 2,225 825
Dynamometer load
N
{kg}
1,090
{111}
1,380
{141}
——
Output (Gross)
kW
{HP}
154
{206}
———
Torque (Gross)
Nm
{kgm}
—
990
{101}
——
Fuel consumption
sec/
300cc
25 — — —
Coolant temperature °C 75 – 94 75 – 94 75 – 94 75 – 94
Lubricating oil
temperature
°C 80 – 110 80 – 110 80 – 110 80 – 110
Lubricating oil
pressure
kPa
{kg/cm
2
}
0.34 – 0.59
{3.5 – 6.0}
——
Min. 0.15
{Min. 1.5}
Exhaust temperature °C Max. 700 Max. 750 — —
To Next Page
Loading...
