KONE Maintenance Method
MX10 / MX20 MCP Procedures - ASME A17.1-2013 / CSA B44-13
© 2014 KONE Corporation PSK8-604-MX10/MX20
All rights reserved.
6 (-) 2014-12-15
1.4 Safety
Refer also to KONE U.S. Safety Policy (SAFETY-01-003) and Elevator Industry Field Employees’
Safety Handbook.
Safety precautions Note
You should develop and follow procedures that
have assimilated the requirements of national lift
codes and other safety related regulations.
In case of conflict between the Code and the
present instructions, a full risk assessment
should be carried out and an appropriate
course of action defined with the local
regulator and company management.
The local safety codes and rules must be obeyed
whenever possible.
Refer to your local procedures to take the elevator
out of use.
Follow the safe working methods defined herein.
In case you are uncertain of the method’s safety,
seek expert advice.
Follow this instruction. Do not skip any step within
the procedures; otherwise there may be a
potentially dangerous situation which you have not
considered.
Warning signs highlight possible hazards.
Be sure that you have the latest maintenance
instruction in use. If you are unsure please
contact KONE.
ENSURE THAT ELECTRICAL EQUIPMENT AND
CONDUCTORS ARE SAFELY DE-ENERGISED
BEFORE WORKING ON THEM.
A locking off system for main electric supply isolator
or other system (for example fuse removal, locking
and tagging system, etc. when applicable) must be
agreed with person responsible for the building
electrification.
Do not connect or disconnect any connectors
when the power is ON.
Personal safety equipment must be available and
used as required.
Handle and dispose of waste materials in
accordance with company procedures that have
assimilated the regulations applicable to your
country/state.
Ensure that your work does not cause a hazard to
others. In particular keep access ways and fire exits
clear.
To Next Page
Loading...