Kone MX20 - Section 1: General Information; 1.1 Warranties, Disclaimers and Notices

KONE Maintenance Method
MX10 / MX20 MCP Procedures - ASME A17.1-2013 / CSA B44-13
© 2014 KONE Corporation PSK8-604-MX10/MX20
All rights reserved.
2 (-) 2014-12-15
Section 1: General Information
1.1 Warranties, Disclaimers and Notices
Illustration Notice:
The illustrations in this manual are generic and may differ in some cases from the material used for
the actual elevator.
DISCLAIMER OF WARRANTIES AND LIABILITIES:
KONE reserves the right at any time to alter the product design, specifications and procedures
reflected in this document. NO STATEMENT CONTAINED IN THIS DOCUMENT IS TO BE
CONSTRUED AS A WARRANTY OR CONDITION, EXPRESS OR IMPLIED, AS TO ANY
PRODUCT, SPECIFICATION OR PROCEDURE, ITS MERCHANTABILITY OR FITNESS FOR ANY
PARTICULAR PURPOSE OR QUALITY, OR AS A MODIFICATION OR REPRESENTATION OF
THE TERMS OF ANY PURCHASE AGREEMENT.
KONE DISCLAIMS ANY LIABILITY RESULTING FROM OR IN CONNECTION WITH THE USE OR
DISCLOSURE OF INFORMATION IN THIS DOCUMENT. KONE HAS NO LIABILITY FOR
TYPOGRAPHICAL OR OTHER ERRORS OR OMISSIONS CONTAINED IN THIS DOCUMENT OR
ANYONE'S INTERPRETATION OF THE INSTRUCTIONS. THE USER OF THIS DOCUMENT
ASSUMES ALL RISKS ASSOCIATED WITH THE USE OR DISCLOSURE OF THIS DOCUMENT.
Trademark Notice:
KONE EcoSpace™, KONE MonoSpace
®
, KONE MiniSpace™, KONE S-MiniSpace™, EcoDisc
®
,
KONE EcoDom
®
3000, KONE TranSys™, KONE Alta™, KoneXion
®
and all other product names
are trademarks or registered trademarks of KONE Corporation in various countries.
General Notice:
This document, including all content other than ASME code content, is the sole and exclusive
property of KONE Inc. and KONE Corporation, and their respective affiliates and subsidiaries
(collectively, “KONE”). This document is protected by U.S. and International intellectual property
laws. KONE reserves the right to modify this document at any time, without notice. KONE makes
no representations or warranties, express or implied, regarding the accuracy of this document and
disclaims any liability for injury or property damage that may arise from use of this document.
Copyright Notice:
Copyright © 2014 KONE Inc. All rights reserved. No part of this document may be reproduced,
copied, modified, or adapted, without the prior written consent of KONE Inc. All ASME code
references contained in this document are reprinted from A17.1-2013/CSA B44-13, by permission of
The American Society of Mechanical Engineers. All rights reserved. No further copies can be made
without written permission.
.