KONE Maintenance Method
MX10 / MX20 MCP Procedures - ASME A17.1-2013 / CSA B44-13
© 2014 KONE Corporation PSK8-604-MX10/MX20
All rights reserved.
23 (-) 2014-12-15
Safety measures: MX10 and MX20
Procedure Note
1. Drive empty car to top landing.
2. Switch elevator to inspection mode.
3. Drive car on inspection to suitable working
position to have access to brakes and so
car is aligned with car blocking device.
4. Engage car blocking device.
5. Exit car roof.
6. Turn OFF main switch.
7. Leave pin of car blocking device loose, so
possible movement of car is noticeable
during brake test.
To Next Page
Loading...