KONE Maintenance Method
MX10 / MX20 MCP Procedures - ASME A17.1-2013 / CSA B44-13
© 2014 KONE Corporation PSK8-604-MX10/MX20
All rights reserved.
32 (-) 2014-12-15
Test manual brake release: MX10
Procedure Note
1. Test brake function by pushing in on pin
to release brake handle (9).
NOTE! Any further adjustments must be
done from cable end nut (4), not from center
nut.
2. Make sure brake handle (9) returns to
brake closed position by itself.
NOTE! If brake handle (9) does not return,
check brake cable and aluminum tube for
sharp radii, twists and other blockages.
To Next Page
Loading...