8
radio-frequency devices must be susceptible with the interference from legal communi-
cations or ISM radio wave radiated devices.
低功率電波輻射性電機管理辦法
第十二條經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自
變更頻率、加大功率或變更原設計之特性及功能。
第十四條低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象
時，應立即停用，並改善至無干擾時方得繼續使用。前項合法通信，指依電信法規定作業之
無線電通信。低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備
之干擾。
U.S. Federal Communications Commission (FCC) Statements
Compliance Statement
The changes or modifications not expressly approved by the party responsible for compli-
ance could void the user’s authority to operate the equipment.
To comply with the FCC RF exposure compliance requirements, this device and its
antenna must not be co-located or operating to conjunction with any other antenna or
transmitter.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interferences that may
cause undesired operation.
When using IEEE 802.11a wireless LAN, this product is restricted to indoor use, due to
its operation in the 5.15 to 5.25GHz frequency range. The FCC requires this product to
be used indoors for the frequency range of 5.15 to 5.25GHz to reduce the potential for
harmful interference to co channel mobile satellite systems. High-power radar is allocat-
ed as the primary user of the 5.25 to 5.35GHz and 5.65 to 5.85GHz bands. These radar
stations can cause interference with and/or damage to this device.
Class B Part 15 Statement
For product available in the USA/Canada market, only channel 1~11 can be operated.
Selection of other channels is not possible.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designated to provide
reasonable protection against harmful interferences in a residential installation. This
NOTICES
To Next Page
Loading...
