501/421/361 11-39
Utility mode
11
11.6 Finisher Adjustment
11.6.1 Half-Fold Position
The folding position when printing with the "Half-Fold" setting can be adjusted for each paper size and for
each paper type.
2
Note
[Half-Fold Position] does not appear if optional finisher and Saddle stitcher are not installed.
If the angle of the center folding position must be adjusted, contact your service representative.
!
Detail
For details on the "Center Staple & Fold" setting, refer to "Binding copies at the center ("Center
Staple & Fold" setting)" on page 2-65.
0 Before making any adjustments, use the "Half-Fold" setting to print a single sample copy. Perform the
adjustment while checking the sample that was created.
1 Display the Administrator Settings screen.
– For details on displaying the Administrator Settings screen, refer to "Displaying the Administrator
Settings screen" on page 11-35.
2 Touch [1 System Settings].
The System Settings screen appears.
3 Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4 Touch [3 Finisher Adjustment].
The Finisher Adjustment screen appears.
5 Touch [1 Half-Fold Position].
The Half-Fold Position screen appears.
6 Touch the button for the paper size to be adjusted.
– If the paper size to be adjusted is not displayed, touch [↑] and [↓] until the desired paper size is
displayed.
7 Compare the width of the left pages of the copy sample with the width of the right pages to check for
the center of the paper.
– If the folding position is too far to the left of the center of the paper, touch [+] to increase the
adjustment (between -5.0 and +5.0).
To Next Page
Loading...
Need help?
General
