501/421/361 1-29
Before Making Copies
1
2
Note
As the factory default, pressing the [Power Save] key causes the machine to enter Low Power mode.
Settings in the Administrator Settings mode can be changed to put the machine in Sleep mode instead.
For details, refer to "System Settings" on page 11-23.
The Low Power mode can also be canceled by pressing any key in the control panel or by touching the
touch panel.
!
Detail
The length of time until the machine enters Low Power mode can be changed.
For details, refer to "System Settings" on page 11-15 and page 11-23.
1.3.7 Automatically conserving energy (Sleep mode)
If no operation is performed for a specified length of time, the machine automatically enters a mode where it
conserves energy.
Although the machine conserves more energy in Sleep mode than in Low Power mode, the machine must
warm up when Sleep mode is canceled to begin printing again, therefore taking more preparation time than
Low Power mode.
As the factory default, the machine enters Sleep mode after 60 minutes (501)/15 minutes (421/361).
To recover from Sleep mode
% Press the [Power Save] key.
– The touch panel comes on again and, after the
machine has finished warming up, it is ready to begin
printing.
2
Note
The Sleep mode can also be canceled by pressing any key in the control panel or by touching the touch
panel.
!
Detail
As a default, the machine enters Low Power mode if no operation is performed for 15 minutes (501)/1
minute (421/361), and then the machine enters Sleep mode after 60 minutes (501)/15 minutes (421/361)
have elapsed.
The length of time until the machine enters Sleep mode can be changed. For details, refer to "System
Settings" on page 11-15 and "System Settings" on page 11-23.
To Next Page
Loading...
Need help?
General
