Specifying settings from the control panel
4
bizhub C351 (Phase3) 4-83
4.14 FTP settings
Settings for sending scan data to FTP servers can be specified.
FTP parameters
The FTP parameters are as follows:
FTP Setting screen 1/3
FTP Setting screen 2/3
FTP Setting screen 3/3
Item Description
Proxy Server Address Sets the proxy server address. Use the keypad in the con-
trol panel to type in the address.
Proxy Port Number Sets the port number of the proxy server. To change the
value, press the [C] (clear) key, and then use the keypad to
type in the value (between 1 and 65535).
Item Description
Port No. Set the port number used to communicate with the FTP
server. To change the value, press the [C] (clear) key, and
then use the keypad to type in the value (between 1 and
65535).
Connection Timeout If the transmission stops while uploading data to the FTP
server, the upload operation is automatically aborted after
a specified time elapses. Set the time from the point when
the transmission stops to the point when the upload oper-
ation is to be aborted. To change the value, press the [C]
(clear) key, and then use the keypad to type in the value
(between 5 and 300 seconds).
Item Description
FTP Client Sets whether to use the Scan to FTP operation.
FTP Server Specify whether to use this machine as an FTP server.
When using the copier as an FTP server, select "ON". When
using an application that links to the copier as an FTP client
of the copier, "ON" must be selected.
To Next Page
Loading...
Need help?
General
