E28
Flow of Measurement
nOptional settings nBasic procedure
Turning power ON (Page 20)
Language selection (Page 104) * As necessary (after initialization, etc.)
Condition settings (Page 59)
Target Mask replacement, etc. (Page 42)
* When required depending on the
measurement conditions
Zero calibration (0% Calibration)
(Page 52)
* Only when required
(after initialization, etc.)
White Calibration (100% Calibration) (Page 55)
*When color difference is measured *When color difference is not measured
Target color settings (Page 76)
Target color selection (Page 132)
Measurement (Page 112)
End
To Next Page
Loading...
