Konica Minolta cm-5 - Setting a Specimen; Reflectance Measurement

E42
Setting a specimen
Reectance measurement
To use the instrument for reectance measurement of specimens other than powder or paste, attach the Target
Mask to the specimen measuring port and set a specimen on it. The Target Mask can be selected from three
types based on the illumination area (specimen measuring port size): ø30 mm, ø8 mm and ø3 mm, depending on
the specimen and application.
Notes
When taking reectance measurements, make sure that there is no object in the transmittance specimen chamber.
Required accessory
Target Mask: ø30 mm
CM-A197
Target Mask: ø8 mm
CM-A196 (Optional)
Target Mask: ø3 mm
CM-A195 (Optional)
For LAV For MAV For SAV
Notes
Do not touch the inside (edge) of the Target Masks with your
ngers. If it becomes dirty, wipe it with a soft, clean dry cloth.
Edge
Attaching the Target Mask to the instrument
1. Align the Target Mask with the positioning groove on
the instrument and push the mask in.
Holding example 1
Holding example 2