13
4. When the symbol lights up，the machine stop working,it will work again after you take out the
ice.
5. Shut down the unit：During the unit making ice，press the“ON/OFF”button on the control
panel，the unit shut down and into standby mode.If you press "ON/OFF" longer than 5S during ice
making, then the unit enters the deicing process directly, this function can help remove the ice on
the ice plate. Press "ON/OFF" to shut down the machine.
6. Timing setting：Setting range： 1-24 hours
Time shutdown：When the unit is running,it can set up the timing shutdown.
Time on：When the unit is on standby,you can set the unit with ON-TIMER.
How to set up the timing
Press the TIMER button, the default timing time is“1H”in display window，then press“+”button to
adjust the timing time you need,every time you press the“+”button,the time add 1 hour;Press“-”button
can reduce the timing time.During the process of time adjustment,The “H” in the lower corner of the
number will flash，then after 5 seconds flashing without pressing, the “H” letter will change from flashing
to always displaying, means the timer program has been completed.
In standby condition display 5H,it means the unit will start automatically after 5 hours;In ice making
condition display 5H,it means the machine will shut down automatically after 5 hours,
the "H" in the display screen indicates that the machine currently has timing function,
and the number in front will be smaller and smaller. Until it becomes zero, the timing
ends, and the machine enters the mode you need.
How to cancel timing
When the unit has a timing（the display window will display XX H),press“TIMER”button，the timing
is canceled after the number on the screen and "H" are extinguished.
When the unit has a timing,the display area in the lower left corner will display the timing time and
the ice making setting time, and the display content will be switched every 5S.
7. Automatic self-cleaning program.
Automatic self-cleaning program, the default cleaning is twice (about 5 minutes). Plug the machine
connected to the pipeline into the power plug, press the "timed cleaning" button on the control panel
for more than 5 seconds, start to enter the automatic cleaning function, the display symbol on the
display dynamically rotates，and after 50 seconds of cleaning, automatic drainage starts,
Drainage is completed after 50 seconds, and then add water automatically, after the standard water
level, it will automatically wash again.
Cancel the self-cleaning program: It takes about 5 minutes to complete one self-cleaning program.
When the program is over, the system will be in off-state automatically. And also you
can press the “ON/OFF” button on control panel to cancel the self-cleaning program by
force.
To Next Page
Loading...
