19
The ice machine cleaner contains acids.
DO NOT use or mix with any other solvent-based cleaner
products.
Use rubber gloves to protect hands. Carefully read the material
safety instructions on the container of the ice machine cleaner.
DISCARD the first batch of ice troduced after cleaning.
10. Then open the water faucet of the main water supply, Let the water flow in the unit.
Again press the“TIMER CLEAN”button on control panel for more than 5 seconds,
to enter the self-Cleaning program. The machine will startself-clean after the water
is enough, The symbol will revolve on the LCD. It will drain the water after 50s
cleaning, add water after 50s draining, and clean again after enough water.
During this process, Through this process, It will rinse the water dividing pipe,
evaporator, water pump, silicone pipe, and water tank, etc.
11. After one self-cleaning program complete, then pull out the Water drainage cap of
the water tank, drain the cleaning solution down to the lower ice storage bin, slightly
to drain out all of the water completely. Then install back the Water drainage cap to
the water tank slot tightly.
12. Repeat the step 10-11 again for 2 times.
13. Following the above program to clean the ice storage bin .
14. Then this special cleaning program finish, you can return to the regular ice making
mode. And suggest to discard the first batch of ice cube.
Cleaning Suggestion
1) DAILY CLEANING
The ice shovel, door and the should be cleaned by yourself per each day. At the end of every day,
rinse the ice shovel and wipe the both sides of the door with a clean cloth.
2) SEMI-MONTHLY CLEANING
The ice shovel, ice bin, water tank, the ice-full detecting plate and the surface of the evaporator
are to be cleaned by yourself semi-monthly according to interior cleaning program.
3) SEMI-ANNUAL CLEANING
All the components & surfaces exposed to water or ice cubes, like ice storage bin, water tank, door,
evaporator, water pump, silicone tube, water dividing pipe, etc. should be cleaned by Using
Nu-Calgon Nickle Safe Ice-machine Cleaner per each 6 months. They should be
cleaned by the serviceman according to ice making assembly system cleaning program.
To Next Page
Loading...
