KoolMore HZB-160F - Initial Setup Procedures; Cleaning Before First Use; Water Connection Procedures

10
Before you move your ice maker into its final location, it is important to make sure you have the proper
electrical connection.
It is recommended that a separate circuit, serving only your ice maker, be provided. Use receptacles
that cannot be turned off by a switch or pull chain. If the supply cord or plug to be replaced, it should be
done by a qualified service engineer.
This appliance requires a standard 110-120Volt, 60Hz electrical outlet with good grounding means.
Recommended grounding method
For your personal safety, this appliance must be properly grounded. This appliance is equipped with a
power supply cord having a grounding plug. To minimize possible shock hazard, the cord must be
plugged into a mating grounding-type wall receptacle, grounded in accordance with the National
Electrical Code and local codes and ordinances. If a mating wall receptacle is not available, it is the
personal responsibility of the customer to have a properly grounding wall receptacle installed by a
qualified electrician.
C
C
L
L
E
E
A
A
N
N
I
I
N
N
G
G
Y
Y
O
O
U
U
R
R
I
I
C
C
E
E
M
M
A
A
K
K
E
E
R
R
B
B
E
E
F
F
R
R
O
O
E
E
F
F
I
I
R
R
S
S
T
T
U
U
S
S
I
I
N
N
G
G
Before using your ice maker, it is strongly recommended to clean it thoroughly.
1. Open the ice getting door.
2. Clean with diluted detergent, warm water and a soft cloth.
3. Repeatedly cleaning the inner tank of the ice bin until the inner tank is clean. And suggest that
you should discard the ice-cube made by the first ice making cycle after cleaning.
4. The outside of the ice maker should be cleaned regularly with a mild detergent solution and warm
water.
5. Dry the interior and exterior with a clean soft cloth.
WATER CONNECTION FOR YOUR ICE MAKER
Important: Be sure to use the new hose-sets supplied with the appliance to
connect to water mains and that old hose-sets should not be reused.
1、Connect the water supplying hose to the unit
Step 1: First remove the tape on the water inlet port for water supply (indicated in the following
illustration “A”) located at unit back, then use your other hand’s finger to press the out circle Step 2:
Insert the one end of the white water hose into the water inlet port, and push inward completely, and
install back the clipper, then water hose connection is completed..
Water inlet port on
the unit back
Then install back
the clipper
White water
hose(accessory)
First insert the water
hose inward
completely
Remove the
clipper first
Unit Back View
STEP 1: Remove the
tape first
STEP 2: Insert the
water hose