18
Ice Making Assembly System Cleaning by Using Nu-Calgon Nickle Safe
Ice-machine Cleaner
Minerals that are removed from water during the freezing cycle will eventually form a hard
scaly deposit in the water system. Cleaning the system regularly helps remove the mineral
scale buildup. How often you need to clean the system depends upon how hard your
water is. With hard water of 4 to 5 grains/liter, you may need to clean the system as often
as every 6 months.
1. Turn off the ice maker. Keep the ice maker connect to the water supply and
drainpipe. But shut off the water faucet of main water supply.
2. Open the door and scoop out all of the ice cubes. Either discard them or save them
in an ice chest or cooler.
3. Remove the front panel of the ice maker
4. Making the cleaning solution. Please mix the Nu-Calgon Nickle Safe Ice Machine
Cleaner with water to make the cleaning solution.
5. Use a plastic or stainless container with more than 5 liters capacity, mix 400 ml
Nu-Calgon Nickle Safe Ice-machine Cleaner with 3.8 liters warm water about
120℉-140℉, Then divide them for 2 shares equally in 2 cups. It is better to keep
the temperature of each cup of the cleaning solution.
6. Check to be sure that the Water drainage cap of the
water tank has been installed properly in the slot of
the tank wall. Then Pour one cup of Nickel-Safe Ice
Maker Cleaning Solution into the water tank. Wait
about for 5 minutes.
7. Turn on the power to the ice maker, then press “TIMER CLEAN”button on control
panel for more than 5 seconds, to enter the self-Cleaning program. The machine
will startself-clean after the water is enough, The symbol will revolve on the LCD. It
will drain the water after 50s cleaning, add water after 50s draining, and clean
again after enough water. Press“Timing/Cleaning”, it will be cancelled if during the
cleaning.
8. After a self-cleaning procedure is completed, pull out the Water drainage cap of the
water tank, drain the cleaning solution down to the lower ice storage bin. Shake the
unit slightly to drain out all of the cleaning solution completely. Then install back the
Water drainage cap to the slot of the water tank.
9. Repeat steps 6--8 to clean the ice making assembly system again.
WARNING
Wear rubber gloves and safety goggles（and/or face
shield）when handing Ice Machine Cleaner or sanitizer.
To Next Page
Loading...
