8
OPERATING PROCEDURES & MAINTENANCE
UNPACKING YOUR ICE MAKER
1. Remove the exterior and interior packaging. Check if all the accessories, including instruction
manual, ice scoop, white water inlet pipe, L-type 3 ways quick connection to 3 ways plug-in ,
adjustable feet 4pcs ,4 ways to 3 ways water quick connector and the water draining pipe, etc.,
are inside or not. If any parts are missing, please contact our customer service.
2. Remove the tapes for fixing the door and inner cabinet, ice scoop, etc.. Roughly clean the inner
cabinet & ice scoop with wet clothe.
3. Put the ice maker on a level & flat floor, without direct sunlight and other sources of heat (i.e.: stove,
furnace, radiator). Maker sure that there is at least 20cm gap between the air outlet and the
obstacles, and at least 5 cm between Left/Right side and the wall.
4. Allow 4 hours for the refrigerant fluid to settle before plugging the ice maker in if the unit maybe fall
upside down during shipping or transportation.
5. The appliance must be positioned so that the plug is accessible.
WARNING: connect to the potable water supplying only. Only use drinking water.
Main machine assembly
1． Screw the four adjustable feet of the attachment into the ice bin. (Notes: The feet should not
be loose.)
2．Put the ice cabinet on the floor and the icemaker on the ice bin. (Notes：No shaking after
finishing the installation)
⑴
⑵
ice bin
Adjustable feet
ice maker
ice bin
To Next Page
Loading...
