16
Using an SD card
You can use an SD card to save or load internal
data.
Audio les (WAVE format or AIFF format) that
you’ve created on your computer can also be
loaded.
Never turn off the power or remove the SD card while
data is being saved or the card is being formatted. Doing so
may render the SD card unusable.
TIP The SD card is not included. It must be pur-
chased separately.
TIP The KAOSSILATOR PRO+ supports SD cards of
up to 2GB capacity and SDHC cards of up to 32GB
capacity.
TIP The KAOSSILATOR PRO+ can handle up to 256
les in total. The unit will not recognize any les that
exceed the 256 le limit.
TIP The KAOSSILATOR PRO+ may take time to rec-
ognize or write les on large capacity cards.
About the write protect setting of an SD card
SD cards have a write protect switch that pre-
vents the data from being overwritten acciden-
tally and lost. If you set the card’s switch to the
protected setting, it will be impossible to write
or erase data on the card, or to format it. If you
need to save edited data on the card, move the
switch back to its original unprotected setting.
Write protect
switch
Protected
Handling SD cards
Please carefully read and observe the instruc-
tions that came with your SD card.
About the contents of the card
The following les and folders will be created in
the root directory of the card.
Files you can save
LOOP REC Data 00–99.o1s
GLOBAL 0–9.o1g
PROGRAM MEMORY Set 0–9.o1p
All Data 0–9.o1a
kaossilator2 loop recorder
data (in the KO2 folder)
KO2D00–99_1.wav
KO2D00–99_2.wav
Files you can load
LOOP REC Data 00– 99.o1s
00– 99.kos
00– 99.wav
00–99.aif
GLOBAL 0–9.o1g
0–9.kog
PROGRAM MEMORY Set 0–9.o1p
All Data 0–9.o1a
0–9.koa
kaossilator2 loop recorder
data (in the KO2 folder)
KO2D00
–
99_1.wav
KO2D00
–
99_2.wav
TIP: If an All data le named “0.o1a” exists on the card,
this le will automatically be loaded when you start up
the KAOSSILATOR PRO+.
TIP: The WAVE or AIFF les that can be loaded must
be 8/16-bit linear PCM mono or stereo les. 8-bit data
will be loaded by lling the lacking bits with zeros.
When loading les created on the computer, the le
name must be changed to a two-digit integer (00–99),
and the le must be placed in the root folder of the SD
card.
TIP: When WAVE or AIFF les are loaded as sample
data, the le is loaded with the appropriate settings for
the loop. Therefore, it may be played back at a differ-
ent speed than on your computer. In addition, if the
data is longer than can be recorded in one bank, it will
be truncated. If the data is shorter than can be record-
ed in one bank, the remaining length will be handled
as silence.
TIP: This device can use les saved with KAOSSILA-
TOR PRO. However, the PROGRAM MEMORY set-
tings cannot be loaded since they are incompatible
with this device.
TIP: This device can load loop recorder data les (in-
cluding the BPM, key, scale and note range settings)
from kaossilator2.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
