- 95 -
(4) At this point, to use an actual KARMA knob, there is an extra step
required. KARMA Knobs don’t show up in the AMS Sources directly.
How do you get them there? Assign a KARMA knob to transmit one of
the CCS that do show up in the AMS List. Go to (Global) (6.1-2a) [Menu]
- [Ctrl] - [KARM1]. Set Knob 1 to transmit MIDI CC#83.
(5) Go back to Program Mode, (7.2-2). Now, set the “Src” AMS parameter
to CC#83. Now you can twist KARMA knob 1, and get an exact manual
sweep of the Phaser.
Note that the methods illustrated above work for anything that is
variable through AMS on any effect, such as Wet:Dry amount, LFO
depth, Reverb Length, etc. The Digital FX are very powerful on this
synth, and there are many ways to control them in real-time. This is just
scratching the surface. I highly recommend studying the “Effects Guide”
section of the ☞ Parameter Guide, Page 159. I also suggest studying
“Alternate Modulation Source,” ☞ Parameter Guide, Page 221.
2. How can I change an effect parameter in my sequence if it
doesn’t have an AMS (Alternate Modulation Source)? For
example, I want to use Effect 012 St. Sub Oscillator, and in one
section of the song I want the OSC Mode to be “Fixed”, and in
another section I would like to change it to “Key Follow.”
If a parameter is not available to be changed via MIDI with an AMS, you
can many times simulate the same thing by using two insert effects, and
switching between the two via MIDI. For example, you could route a
timbre through IFX 1, set to Effect 012 with OSC Mode “Fixed”, and then
chain this into IFX 2, also set to Effect 012 but with OSC Mode “Key
Follow” Then set up the W/D parameter (on both) to be controlled by a
knob or switch. The amount of that controller should be set to +99 for
one of the effects, and -99 for the other. You could then use that
controller to turn one effect OFF while turning the other ON (switch from
CC value 0~127).
3. Is it possible in sequencer mode to assign more than one Insert
Effect to a track?
Yes, you can assign all 5 IFX (Insert Effects) to the same track/timbre if
you want to. The way you do this is to assign the Bus Select to the first
Insert Effect you want to use, and then “chain” its output into the next
IFX. You do this on (7.2-1) [Menu]-[IFX]-[Setup]. The little “arrow” box
routes each Insert Effect either into the next Insert Effect, or into the
Master Effects. ☞ Parameter Guide, Page 39.
To Next Page
Loading...
