- 96 -
Note that this means you can run IFX 2 into IFX 3, but not IFX 2 into 4
(skipping 3). They have to be next to each other. If you run into IFX 1,
and turn all the Chains On, then you are running through all 5 IFX at
the same time.
Note that this means you are running them through each other, so it’s
not exactly the same as putting 2 or more separate effects on the same
track (individually). So you need to think about what order you want
things in, because the order can affect the sound. Generally, you put
things like compressors and EQs first, and things like delays and reverbs
last, but there’s no hard and fast rules – it depends what you are trying
to achieve.
4. I copied all the effects for a Program into the Sequencer/Combi,
but I'm still missing something because the sound of the timbre
is still lacking the fullness of the original Program.
I think I can guess what the problem is. You have to set the BUS
settings properly. This does not get copied with the Insert FX - you
would think maybe it should, since without setting this right it
sometimes doesn't matter if you copied the Insert FX correctly ;-)
If you look at the BUS page in the Program, you will see that “Bus Select”
is set to IFX1. So in the Combi/Seq, you must do the same thing for
Timbre1. (7.1-1) [Menu]->[BUS].
In this example, if the Bus Select is set to "L/R" (as it is by default in the
Combi, you just run into the Master FX based on the values below the
Bus Select field (and the Insert FX have no effect on the timbre). If you
change Bus Select to IFX 1, the timbre is routed through Insert FX1 (and
then whatever else you have chained together on the Insert FX IFX Page).
5. How can I apply Master Effects to tracks that are already being
routed through Insert FX?
When you have NO Insert Effects assigned to a Timbre/Track, you use
the Send 1/Send 2 Levels on (7.1-1a) to control how much of each
Master Effect is applied to a timbre/track.
When Insert Effects are being used, the Send1/Send2 fields here are
grayed out and unavailable. Then, you use the Send1/Send2 fields on
the Insert Effects setup Page (7.2-1) [IFX] - [Setup] ☞ Parameter Guide,
Page 112. Each Insert Effect can be sent through the Master Effects this
way. When more than one Insert Effect is chained to another one, only
To Next Page
Loading...
