Parameters of each mode
22
Timbre Parameters
Here you can select the program used by each timbre, and
set the output level, pan, and output destination of each tim-
bre.
Timbre Select .............................................................[1…8]
This selects the current timbre that is available for editing.
To select a timbre, click the timbre number or the bar shown
at either edge of the parameter area.
When you click the on-screen keyboard or drag the pitch
bend or modulation wheel to operate them, MIDI messages
will be transmitted on the MIDI channel of the timbre
you’ve selected here. If you’re controlling the M1 software
synthesizer from an external MIDI device, you won’t hear
anything unless the MIDI channel of your external MIDI
device matches the MIDI channel of the timbre you’ve
selected here. The same applies to the pitch bend wheel and
modulation wheel.
The editing area at the right will show the parameters
(selected by the [Page Select] switches) of the program used
by this timbre, allowing you to edit them.
MIDI Indicator (Timbre indicator)
When a timbre receives MIDI messages from the on-screen
keyboard or pitch bend wheel etc., or from an external MIDI
device, the number of that timbre (i.e., the timbre of the
matching channel) will light. However, this indicator will
not light in response to incoming MIDI realtime messages.
SOLO....................................................................[OFF, ON]
Only timbres for which this is on will play.
MUTE....................................................................[OFF, ON]
Timbres for which this is off will not play.
IFX........................................................................[OFF, ON]
Switches the insert effect on/off.
OFF (dark): The insert effect section is bypassed.
ON (lit): The insert effect section is active.
Timbre Select
MIDI Indicator
Menu Commands
To Next Page
Loading...
Need help?
General
