Korg M1 - Multi Mode Parameters

Parameters of each mode
48
AFTER TOUCH
☞ M1 owner’s manual PDF, page 32 “F7-1: AFTER
TOUCH”
PITCH .......................................................[–12…+00…+12]
Specifies the degree to which aftertouch will affect the pitch.
PITCH MG .............................................................. [00…99]
Specifies the degree to which aftertouch will affect the
PITCH MG depth.
CUTOFF VDF .............................................[–99…+00…+99]
Specifies the degree to which aftertouch will affect the VDF
cutoff frequency.
VDF MG.................................................................[00…99]
Specifies the degree to which aftertouch will affect the VDF
MG depth.
VDA AMPLITUDE .......................................[–99…+00…+99]
Specifies the degree to which aftertouch will affect the VDA
volume change.
VDA MG................................................................[00…99]
Specifies the degree to which aftertouch will affect the VDA
MG depth.
CONTROLLER
☞ M1 owner’s manual PDF, page 33 “F7-2: JOY STICK”
PITCHBEND ...............................................[–12…+00…+12]
Specifies the pitch bend range of an external controller.
This setting may have no effect, depending on the Glo-
bal mode “GLOBAL PITCHBEND Switch” setting. (☞
“GLOBAL PITCHBEND” on page 66)
VDF SWEEP INT.........................................[–99…+00…+99]
Specifies the amount of VDF cutoff frequency change pro-
duced by an external controller.
PITCH MG INT ........................................................[00…99]
Specifies the degree to which an external controller will
affect the PITCH MG depth.
PITCH MG FREQ/PITCH MG TIMES ..............................[0…3]
Specifies how an external controller will affect the PITCH
MG speed as a ratio relative to the “FREQ/TIMES” value of
the OSC page.
This setting will be either PITCH MG FREQ or PITCH MG
TIMES, depending on the OSC page “TEMPO SYNC” set-
ting.
VDF MG INT...........................................................[00…99]
Specifies the degree to which an external controller will
affect the VDF MG depth.