Writing, saving, and loading data
72
Writing
1. Click the [WRITE] button in the OSC page DRUMS sec-
tion of each mode.
The WRITE DRUM KIT dialog box will appear with the
attribute that is specified for the drum kit selected.
2. Select the writing-destination card.
Click either [USER 1] or [USER 2] shown below.
3. If you want to change the name before saving, double
click on the drum kit name displayed in the OSC Edit
screen and using your computer’s keyboard, type in a
name and press the [Enter] key.
4. Select the desired attribute(s) for this drum kit.
You may select more than one attribute by holding
down the [Shift] key on your computer.
5. Click the [OK] button.
The drum kit will be written to the user card.
Saving data on your computer
Here’s how the M1 software synthesizer’s internal data can
be saved as a file on your computer.
[FILE] button
1. Click the [FILE] button displayed in the upper left of the
screen in each mode. In the menu that appears, choose
“Save” → “data to save.”
All Data…
The currently loaded parameters of all modes, the Mas-
ter Volume setting, and all user data (combinations, pro-
grams, and drum kits) will be saved.
This data consists of an “.fxb” file (containing the banks)
and an “.m1all” file (All Data).
1 Combination…
The currently loaded parameters of Combination mode
will be saved. The file will have an extension of
“.m1combi”.
1 Multi…
The currently loaded parameters of Multi mode will be
saved. The file will have an extension of “.m1multi”.
To Next Page
Loading...
Need help?
General
