Parameters of each mode
62
OSC
OSC BALANCE ..........................................[–50…+00…+50]
These parameters are the same as in the “PERFORMANCE
page” of Combination mode. Refer to “PERFORMANCE
page” on page 25.
VDF
RESONANCE.............................................[–50…+00…+50]
CUTOFF ....................................................[–50…+00…+50]
EG INT......................................................[–50…+00…+50]
These parameters are the same as in the “PERFORMANCE
page” of Combination mode. Refer to “PERFORMANCE
page” on page 25.
VDF&VDA EG
ATTACK TIME.............................................[–50…+00…+50]
DECAY TIME ..............................................[–50…+00…+50]
RELEASE TIME............................................[–50…+00…+50]
These parameters are the same as in the “PERFORMANCE
page” of Combination mode. Refer to “PERFORMANCE
page” on page 25.
INSERT FX
IFX BALANCE ............................................[–50…+00…+50]
These parameters are the same as in the “PERFORMANCE
page” of Combination mode. Refer to “PERFORMANCE
page” on page 25.
EASY page
Here you can edit the major parameters of the program.
Click the [EASY] switch to access this page. The parameters
are the same as in Combination mode. Refer to “EASY page”
on page 34.
OSC page
Here you can edit the oscillator settings of the program.
Click the [OSC] switch to access this page. The parameters
are the same as in Combination mode. Refer to “OSC page”
on page 37.
VDF page
Here you can edit the VDF settings of the program. Click the
[VDF] switch to access this page. The parameters are the
same as in Combination mode. Refer to “VDF page” on page
42.
To Next Page
Loading...
Need help?
General
