Korg M1 - Page 39

Combination mode
35
OSC
OSC MODE................................... [SINGLE, DOUBLE, DRUM]
Selects the oscillator mode.
MULTISOUND 1/MULTISOUND 2/DRUMKIT........ [BROWSER]
Here you can select a multisound or drum kit.
Click the [BROWSER] switch to access the browser (☞ “The
Browser” on page 16), and make your selection by dragging
up/down or by clicking (Key Focus) and using your com-
puter’s up/down/left/right cursor keys.
LEVEL .................................................................... [00…99]
Specifies the oscillator’s output level.
LINK EDIT .............................................................[OFF, ON]
ON: The VDF, VDF EG, and VDA EG parameters will be
linked between 1 and 2.
OFF: The VDF, VDF EG, and VDA EG parameters can be
adjusted separately for 1 and 2.
The “LINK EDIT” setting has no effect in the OSC –
VDA pages.
SELECT.................................................... [SELECT1, SELECT2]
Switches VDF Select, VDA EG Select, and VDA EG Select in
a single operation.
SELECT 1: Switch to VDF1, VDF EG1, and VDA EG1.
SELECT 2: Switch to VDF2, VDF EG2, and VDA EG2.
VDF
VDF SELECT
Specifies whether the VDF1 or the VDF2 will be shown in
the foreground.
CUTOFF ................................................................. [00…99]
Specifies the cutoff frequency. Drag the point in the graphic.
RESONANCE ......................................................... [00…99]
Specifies the resonance. Drag the point in the graphic.
RESONANCE Switch..............................................[OFF, ON]
Turns resonance on/off.
☞ “RESONANCE Switch” on page 43
EG INT 1 ............................................................... [00…99]
Specifies how deeply the VDF EG1 will be applied.
EG INT 2................................................................ [00…99]
Specifies how deeply the VDF EG2 will be applied.