73
Singing with a connected microphone
Connecting a microphone
Quick Guide
6 Sing into the microphone, and adjust the input gain and the Microphone
volume, until you achieve the correct settings.
Note: You have a cor-
rect microphone volume
setting when the MIC IN
LED stays green most of
the time. The MIC/IN
slider must be set
accordingly, to compen-
sate a too loud or weak
incoming signal.
7 Press the HARMONY and EFFECT buttons to turn their LED on, and acti-
vate the Voice Processor.
8 Try the ON button in the MIC SETTING section, to turn the whole micro-
phone section on/off.
Look at the Mic Mute and Harmony Mute buttons in the display, while you use the MIC SET-
TING buttons o the control panel.
9 Touch the Volume tab to select the Volume panel.
While in this panel, you can use the Play/Mute button of the MIC/IN track in the display, to
mute/unmute the microphone section.
10 If you like, start a Style or Song. Adjust the microphone final volume
using the dedicated slider.
i
Adjust the input level by using the GAIN knob next to
the MIC input. Sing into the microphone, and watch
at the MIC IN LED on the control panel – it ought to
stay green. If it goes orange too often (or even red),
turn down the input gain; if it turns off too often,
increase the input gain. No hint of distortion should
be heard in the audio system when you sing.
While you adjust
the gain, gradually
increase the Micro-
phone volume, by
using the corre-
sponding slider.
Microphone muted Microphone set to
play
To Next Page
Loading...
