Operation
47
As an example, here’s how to erase the In–Out region of
track 1.
1 Register marks at the desired In and Out time loca-
tions. (→p.35)
2 Display the “EditTrk” (track edit) page. (→Copy
Track 2 )
3 Select “ErsTrack” (erase track).
Select “ErsTrack.” Then press the [CURSOR] right key.
4 Select the “DestTrk.”
Use the dial to select the track number that you want
to erase. For this example, select track “1.” Then press
the [CURSOR] right key.
5 Select the “EditMode.” (→Copy Track)
6 Select the “InTime” and “OutTime.”
For each point, use the dial to select a mark number
that you registered. Then press the [CURSOR] right
key.
By pressing the [CURSOR] down key, you can edit the time
location of the selected mark. You can also press the [PLAY]
key to play back the sound for approximately two seconds
from the selected time location.
7 Execute the operation.
When the display asks “ErsOK?,” press the [CURSOR]
right key to execute the operation. When the data has
been erased, the display will indicate “Finish!”
8 Press the [PLAY] key to play back, and verify that the
operation occurred as you intended.
You can press the [UNDO] key to return to the state prior to
executing. (→p.21)
Delete Track – deleting a track
This operation deletes the specified region (In–Out) of the
recorded track data. When data is deleted, the data fol-
lowing the deleted region (i.e., the data following the Out
location) will be moved forward.
Here’s how to delete the In–Out region of track 1.
1 Register marks at the desired In and Out time loca-
tions. (→p.35)
2 Display the “EditTrk” (track edit) page. (→Copy
Track 2 )
3 Select “DelTrack” (delete track).
Select “DelTrack.” Then press the [CURSOR] right key.
In
Out
Blank
DestTrk
DestTrk
To Next Page
Loading...
