Effect
209
Master EQ
Use 7.2: MasterFX MEQ page in Program, Combination
modes and 7.2: Master FX MEQ page in Sequencer mode.
You cannot use the Master EQ in Sampling mode.
You cannot use the Master EQ for the Insert Effect or Master
Effects.
a: Gain, b: Gain, c: Gain
These parameters are linked with the “Master EQ Gain [dB]” (7.2–
1c) parameter of the Master FX.
d: Low Gain Mod-Src
For example, when this parameter is set to Kb1#17, you can con-
trol the EQ gain in the range from –18dB to +18dB during perfor-
mance using the [REALTIME CONTROLS] knob. At this time, set
Knob 1-B to Knob Mod1 (CC#17) for “Knob B-Assign” (Program,
Combination, Sequencer 2.2–1a). The 12 o’clock position of the
knob corresponds to the “Low Gain” value here.
e: High Gain Mod-Src
For example, when this parameter is set to Kb2#19, you can con-
trol the EQ gain in the range from –18dB to +18dB during perfor-
mance using the [REALTIME CONTROLS] knob. At this time, set
Knob 2-B to Knob Mod2 (CC#19) for “Knob B-Assign” (Program,
Combination, Sequencer 2.2–1a). The 12 o’clock position of the
knob corresponds to the High Gain value here.
Master EQ
a
Low Cutoff 20...1.00KHz
Sets the cutoff frequency of Low EQ (shelving type)
Gain –18.0...+18.0 (0.5step)dB
Sets the gain of Low EQ
b
Mid Cutoff 300...10.00KHz
Sets the cutoff frequency of Mid EQ (peaking type)
Q0.5...10.0 (0.1step)
Sets the band width of Mid EQ. With a higher value, the band
become narrower.
Gain –18.0...+18.0 (0.5step)dB
Sets the gain of Mid EQ
c
High Cutoff 500...20.00KHz
Sets the cutoff frequency of High EQ (shelving type)
Gain –18.0...+18.0 (0.5step)dB
Sets the gain of High EQ
d
Low Gain Mod-Src
Selects the modulation source for Low Gain
Off...Tempo
e
High Gain Mod-Src
Selects the modulation source for High Gain
Off...Tempo
Left
Right
Low Mid High
D
-mod
D
-mod
LEQ
Low Gain Mod.
Low Gain Mod - Src
High Gain Mod - Src
High Gain Mod.
PEQ HEQ
LEQ PEQ HEQ
L/Mono
R
To Next Page
Loading...
