PROG
1.1
2.12.23.14.14.25.15.25.36.17.17.2
PROG
1.1
2.12.23.14.14.25.15.25.36.17.17.2
29
Swap Master Effect
This command swaps (exchanges) the settings of MFX1 and
MFX2.
1 Select “Swap Master Effect” to access the dialog box.
2 To execute the Swap Master Effect command, press the
[F8] (“OK”) key. To cancel, press the [F7] (“Cancel”) key.
Select by Category
Selects master effects by category.
For the procedure, refer to “Select by Category” (☞p.2).
This command is valid when the 7.2–1a parameters are
on.
7.2–2: MFX 1 (Master Effect1)
7.2–3: MFX 2 (Master Effect2)
Indicates effect parameter settings for the MFX1 and 2
effects that were selected in the Setup page (
☞p.164–).
Effect dynamic modulation (Dmod) is controlled on the
global MIDI channel “MIDI Channel” (GLOBAL 2.1–
1a). (
☞p.217 “Dynamic Modulation Source (Dmod)”)
■ 7.2–2(3)a: UTILITY
☞ “Write Program” (1.1–1c)
7.2–4: MEQ (Master EQ)
The master EQ is a three-band stereo EQ. It is used to adjust
the overall tonality of the sound immediately before the L/R
bus is output to the AUDIO OUTPUT (MAIN OUT) L/
MONO and R jacks (
☞p.209). The MEQ High Gain and the
MEQ Low Gain can be controlled by assigning a modualtion
source to the “Low Gain Mod-Src.” and “High Gain Mod-
src.” functions on this page.
■ 7.2–4a: UTILITY
☞ “Write Program” (1.1–1c)
7.2–2a
7.2–4a
To Next Page
Loading...
