DSP-62-AEC, DSP-62-UC – Using the Embedded Webpages
Using the Embedded Webpages
The device can be operated locally or remotely using its embedded web software. The web
servers’ interface is accessed using a browser, (see Browsing the DSP-62 Webpages
on page 14).
Before attempting to connect:
• Perform the procedures in Connecting through Ethernet on page 11.
• Ensure that your browser is supported.
The following operating systems and Web browsers are supported:
Some features might not be supported by some cellphone operating systems.
The device’s webpage enables performing the following functions:
• Using the Top Status Bar on page 15.
• Processing Audio Signals on page 18.
• Routing Inputs to Outputs on page 32.
• Mixing Audio Signals on page 36.
• Defining Audio Settings on page 39.
• Defining Video Settings on page 40.
• Defining General Settings on page 42.
• Viewing Device Information on page 50.
Some of the same tasks can be carried out via DSP, Matrix, and Mixer pages for your
convenience. For example, you can link analog input and output pairs through any of these
three pages.
Browsing the DSP-62 Webpages
To browse the device’s webpages:
1. Open your Internet browser.
2. Type the device’s IP Address in the Address bar of your browser. For example, the
default IP Address:
3. The authentication page appears.
To Next Page
Loading...
Need help?
General
