4. If required, split the audio and video sources (for example, the E1 decoder streams the
video, and the other decoder streams the audio).
Figure 12: Streaming Audio and Video from Separate Sources
The video and audio signals are routed from the encoder to the decoder.
Routing a USB Signal
To route a USB signal, perform the following actions.
• Configuring KVM Settings on page 18.
• Routing the USB Signal on page 19.
Configuring KVM Settings
Configure each decoder to enable passing a USB signal between encoders and decoders
To configure KVM settings:
1. Access the decoder UI.
2. In the Navigation pane, Select Main>AV Routing. The AV Routing page appears.
To Next Page
Loading...