KDS-7-MNGR – Using KDS-7-MNGR Embedded Web Pages
3. Select the KVM Combiner tab.
Figure 13: Main Page – KVM Combiner Tab
4. Set USB over IP to USB Emulation, to enable USB pairing function.
When in the USB Emulation mode, you can use only a keyboard and mouse, smart boards,
and storage devices on the decoder.
KVM settings are configured.
Routing the USB Signal
To route the USB signal an encoder to a decoder:
1. In the Navigation pane, Select Main>AV Routing. The AV Routing page appears (see
Figure 9).
2. Select the USB signal tab.
3. Check the cross-point between an encoder and decoder.
Figure 14: Switching a USB Signal
The USB signal is routed from the encoder to the decoder.
To Next Page
Loading...