Setting IR Signal Direction
Set the signal direction for the specific encoders and decoders.
To route a signal from an encoder to a decoder:
1. In the Navigation pane, Select Device Management>Devices. The Device
Management page appears (see Figure 9).
Figure 16: Device Management Page – Setting IR Direction
2. Under IR Direction, set the IR direction for each decoder and encoder, as needed
(see Setting IR Signal Direction on page 21). For example, set the IR direction as
follows:
▪ In on the encoder
▪ Out on the decoder.
Figure 17: Setting IR Direction
Routing the IR Signal
To route the IR signal:
1. In the Navigation pane, Select Main>AV Routing. The AV Routing page appears (see
Figure 9).
2. Select the IR signal tab.
To Next Page
Loading...