Defining CEC Operation Mode on the Encoder/Decoder
Configure CEC to enable CEC signals pass-through to a specific connected device.
To set CEC Gateway:
1. In the Navigation pane, click Control. The Control>Settings page appears.
Figure 22: Control > Settings Page – CEC Settings
2. Click Disable to disable CEC Gateway.
CEC Gateway is disabled.
Routing the CEC Signal
To route a signal from an encoder to a decoder:
1. In the Navigation pane, Select Main>AV Routing. The AV Routing page appears (see
Figure 9).
2. Select the CEC signal tab.
To Next Page
Loading...