KDS-7-MNGR – Using KDS-7-MNGR Embedded Web Pages
To Manage HDMI Parameters:
1. In the Navigation pane, Select Device Management>HDMI. The HDMI tab appears.
Figure 34: HDMI Tab
2. Next to the device ID, mark the checkbox to make changes to a specific device.
3. Click HDCP Enable drop-down box to set HDCP status for each device.
4. Click HDMI Output drop-down box to set a decoder’s output resolution.
When set to Pass Through, the output resolution is configured by the EDID of the
encoder and the player’s configuration.
5. Click EDID drop-down box to select any of the following EDID types:
▪ Select Default to read the default EDID
▪ Select an EDID from the list
▪ Upload an EDID file to a selected encoder.
6. Click APPLY.
7. Click SAVE to save the EDID to a local PC.
8. For each decoder, click TV ON/TV OFF to control the display that is connected to that
decoder via CEC command.
HDMI signal is configured.
Managing Firmware Upgrade
KDS-7-MNGR enables viewing the firmware status as well as upgrading the firmware for one
or more devices at once.
A green indication light next to a device, indicates that a device is online.
To Next Page
Loading...