Kramer VM-214DT - Page 55

Kramer Electronics Ltd.
VM-214DT – Protocol 3000
53
ROUTE
Command Name
Permission
Transparency
Set:
ROUTE
End User
Public
Get:
ROUTE?
End User
Public
Description
Syntax
Set:
Set layer routing
#ROUTE␠layer, dest, src␍
Get:
Get layer routing
#ROUTE?␠layer, dest␍
Response
~ nn@ ROUTE␠ layer, dest, src ␍␊
Parameters
layer –
• 1 Video
• 2 Audio
• 3 Data
• 4 IR
• 5 USBsee
dest - * - ALL
x - disconnect, otherwise destination id
src - source id
Response Triggers
Notes
This command replaces all other routing commands
The GET command identifies input switching on Step-in clients
The SET command is for remote input switching on Step-in clients (essentially via by the Web)
SECUR
Command Name
Permission
Transparency
Set:
SECUR
Administrator
Public
Get:
SECUR?
Not Secure
Public
Description
Syntax
Set:
Start/stop security
#SECUR␠security_mode␍
Get:
Get current security state
#SECUR?␍
Response
Set: ~nn@SECUR␠security_mode␠OK ␍␊
Get: ~nn@SECUR␠security_mode ␍␊
Parameters
security_mode – 1/ON - enables security, 0/OFF - disables security
Response Triggers
Notes
The permission system works only if security is enabled with the “SECUR” command