49
Contrast 3..8 0BC 0..180
Saturation 3..8 0B9 0..180
Hue 3..8 0BA -180..180
Sharpness 3..8 080 -7..+7
Luma delay 3..8 0BD -4..3
Adjust transitions (on certain models only)
Transition type 112 0..2 = Cut, fade, wipe
Switching fade time 0F5 0 (off) to 50 (5.0 seconds)
Wipe type 145 0 = Left -> Right
1 = Right -> Left
2 = Up -> Down
3 = Down -> Up
4 = Diagonal
5 = Diamond
Wipe Size 146 10..2000
Adjust resolutions
Note: You MUST set the 'Image to adjust' value to the correct value first, and only
then change the other values - otherwise you may be adjusting the wrong entry. The
user should not adjust the 'Image to adjust' entry using the front panel whilst also
accessing it via RS232
Image to adjust 081 1..1000
Interlaced 0CA 0..1 = Off, On
H.freq.crse 0BE 10000..200000
H.freq.fine 0BF 10000..200000
H/V active (H) 096 64..2047
H/V active (V) 097 64..2047
H/V start (H) 08B 0..1023
H/V start (V) 08C 0..1023
Clks/l 08D 64..4095
Lines/f 08E 64..2047
H/V sync (H) 08F 8..1023
H/V sync (V) 090 1..1023
Sync polarity 094 0..3 = ++, +-, -+, --
System
SW (Software version) 0D2 Read only
PT (Product type) 0C4 Read only
BT (Board type) 0C2 Read only
Advanced menus 11D 0..1, Off, On
Store 0C8 Set to 1 to store
Buzzer 0CB 0..1 = Off, On
Power cycles 0D6 Read only
Firmware updates 0DD Read only
Hours in use 0D7 Read only
To Next Page
Loading...
