Kramer VS-62H - Configuration and Maintenance; DIP-switch Settings

VS-62H - Configuring and Maintaining the VS-62H
21
9 Configuring and Maintaining the VS-62H
This section describes the configuration and maintenance of the VS-62H and
consists of:
 Setting the DIP-switches (see Section 9.1)
 Resetting the device to factory default settings (see Section 9.2)
 Upgrading the firmware (see Section 9.3)
9.1 Setting the DIP-switches
The DIP-switches dictate the behavior of the VS-62H.
All DIP-switches are off by default.
#
Feature
Description
1
HDCP support on inputs
On—Disable HDCP support on all inputs
Off—Enable HDCP support which is
defined by P3000 commands
2
Video mode switching Output 1
On—Auto
Off—Manual
3
Last connected/Priority mode Output 1
When DIP-switch 2 is set to Auto (ON):
On—Enable Last Connected mode
Off—Enable Priority mode where the
priority of each input is defined by the input
number, (1 is the highest priority)
4
Video mode switching Output 2
On—Auto
Off—Manual
5
Last connected/Priority mode Output 2
When DIP-switch 4 is set to Auto (ON):
On—Enable Last connected mode
Off—Enable Priority mode where the
priority of each input is defined by the input
number, (1 is the highest priority)