Kramer VS-62H - Protocol 3000 Commands

VS-62H - Protocol 3000
43
15.2 Kramer Protocol 3000 Commands
The following table lists the Protocol 3000 commands that the VS-62H supports.
For a full description of the commands, see the Kramer Protocol 3000 document
available from http://www.kramerelectronics.com.
Command
Description
#
Protocol handshaking
AUD
Switch Audio only
AUD-EMB?
Get audio-in-video embedding status
BUILD-DATE?
Read device build date
CPEDID
Copy EDID data from the output to the input EEPROM
DEF-RES
Assign custom defined scaled video output resolution to “vic” index
DEF-RES?
Get custom defined video resolution
DISPLAY
Valid / Invalid output
DISPLAY?
Get output HPD status
ETH-PORT
Change protocol Ethernet port
ETH-PORT?
Get protocol Ethernet port
FACTORY
Reset to factory default configuration
HDCP-MOD
Set HDCP mode
HDCP-MOD?
Get HDCP mode?
HDCP-STAT?
Get HDCP signal status
HELP
List of commands
LOCK-FP
Lock front panel
LOCK-FP?
Get status of front panel lock
MODEL?
Read device model
MTX-MODE?
Get switch mode
NAME
Set machine (DNS) name
NAME?
Get machine (DNS) name
NAME-RST
Reset machine name to factory default (DNS)
NET-DHCP
Set DHCP mode
NET-DHCP?
Get DHCP mode
NET-GATE
Set Gateway
NET-GATE?
Get Gateway
NET-IP
Set IP address
NET-IP?
Get IP address
NET-MAC?
Read MAC address
NET-MASK
Set subnet mask
NET-MASK?
Get subnet mask
PRIO?
Get input priority
PROTOCOL START
Change description in documentation
PROT-VER?
Read device protocol version