Kramer VS-66H

Operating the VS-66H 6x6 HDMI Matrix Switcher
KRAMER: SIMPLE CREATIVE TECHNOLOGY
14
7.2.3 Acquire an EDID from Several Connected Outputs (Auto)
To acquire or change the EDID of several output displays
1
1. Turn the VS-66H ON.
:
2. Connect the required acceptors to the outputs from which you want to
acquire the EDID.
3. Press the EDID and STO buttons simultaneously and hold them for 3
seconds.
Both buttons flash.
4. Press the input button to which the EDID will be copied.
The selected input number flashes on the display.
5. Press the OFF button until the numeric – (hyphen) appears on the display.
6. Press the EDID button.
The process is complete when the display returns to normal.
7.2.4 Acquire the Default EDID
To reset to the default EDID, do the following:
1. Turn the VS-66H ON.
2. Press the EDID and STO buttons simultaneously and hold them for 3
seconds.
Both buttons flash.
3. Press the input button to which the EDID will be copied.
The selected input number flashes on the display.
4. Press the OFF button until a "0" (zero) appears on the display.
5. Press the EDID button.
The process is complete when the display returns to normal.
7.3 Storing and Recalling a Setting
You can use the STO and RCL buttons to store up to 12 setups and then
recall them.
To store a setting:
1. Set the machine to the desired setting.
For example, press the OUT 3 button and IN 4 button
2
1 The EDID acquired is a weighted average of all the connected outputs. For example, if several displays with different
resolutions are connected to the outputs, the acquired EDID supports all the resolutions, as well as other parameters included
in the EDID
.
2 You can set all the switcher IN-OUT buttons